Products from OldtimerWerk
Auf unsere Eigenfertigungen aus Meisterhand sind wir ein wenig Stolz. So stellen wir zum Beispiel fertig gebördelte Bremsleitungssätze zusammen, die euch auch das mühsame Zusammenstellen von Einzelkomponenten ersparen. Und Teile, die große Anbieter mangels Stückzahl nicht mehr produzieren wollen, nehmen wir selber in die Hand und fertigen Sie nach.
No results were found for the filter!
Gasket set for crankcase, Scirocco, Golf 2 16V,... On offer is a gasket set for the crankcase (engine block without cylinder head) with everything you need. Consisting of: Oil seal for crankshaft gearbox side 2X oil seal 47x10 mm, crankshaft, intermediate shaft Seal for crankshaft oil...
€56.95 * €61.60 *
Assembly and sealing kit for tank T3 up to year... We offer a gasket set which contains everything you need to fit the tank. The assembly kit consists of: Seal for fuel filler neck Ventilation hose complete with elbow piece 3X seal for pressure equalization line O-ring seal for tank...
€134.95 * €143.45 *
Gasket set for tank T3 up to year 83 38/70mm OE... We offer a gasket set which contains everything you need to fit the tank. The assembly kit consists of: Seal for fuel filler neck 3X seal for pressure equalization line O-ring seal for tank sensor 2X seal for fuel expansion tank 1 meter...
€39.95 * €42.44 *
Steering knuckle, wheel bearing housing left,... On offer is a completely pre-assembled steering knuckle, suitable for Golf 1 &Co for the driver's side. This makes replacement much easier and no special tools are required. We have assembled the wheel bearing housing from the following...
€199.95 * plus
Deposit
Deposit
Steering knuckle, wheel bearing housing right,... On offer is a completely pre-assembled steering knuckle, suitable for Golf 1 &Co for the Passenger side. This makes replacement much easier and no special tools are required. We have assembled the wheel bearing housing from the following...
€199.95 * plus
Deposit
Deposit
Strut or shock absorber (BILSTEIN) completely... On offer is a set of completely pre-assembled shock absorbers (BILSTEIN) for the rear axle. This means that the shock absorbers can be replaced relatively easily. In addition, no special tools are required. The lower shock absorber bolts...
€364.95 *
Viewed