Products from OldtimerWerk
Auf unsere Eigenfertigungen aus Meisterhand sind wir ein wenig Stolz. So stellen wir zum Beispiel fertig gebördelte Bremsleitungssätze zusammen, die euch auch das mühsame Zusammenstellen von Einzelkomponenten ersparen. Und Teile, die große Anbieter mangels Stückzahl nicht mehr produzieren wollen, nehmen wir selber in die Hand und fertigen Sie nach.
Anschrift:
OLDTIMERWERK
Zu den Mühlen 6
75399 Unterreichenbach
Deutschland
Telefon: +49 7231/6076574
E-Mail: [email protected]
No results were found for the filter!
Bracket for Multivan planking on the doors,...
We are offering a new holder for the driver or front passenger, including mounting materials. Four pieces are installed per vehicle. Two pieces per door. The set consists of the following individual parts: 1x set: Base for mounting the...
€9.15
*
€9.84
*
Holder for Multivan planking on sliding door,...
We are offering a new holder for the sliding door, including mounting materials. There are 4 pieces installed per vehicle. The set consists of the following individual items: 1x set: Base for mounting the panelling T3 Carat and Multivan...
€9.95
*
€10.60
*
Mounting kit for fiberglass plastic planking T3...
Complete 136-piece assembly kit for the GRP paneling of the T3 bus. The set consists of the following individual items: 17x carpet pad for mounting the T3 Carat and Multivan OE Ref. 255853999 cladding 34x rivets, cup rivets, blind rivets...
€54.95
*
€62.05
*
Steering gear for power steering complete kit,...
In this Golf 1 Cabrio & Co steering gear for power steering - set you have the following items: 1x steering gear for power steering 2x tie rod / tie rod ends complete 2x steering boot incl. clamps 2x bracket for steering gear 1x rubber...
€719.95
*
€789.11
*
Brakes set for fixed caliper brake Front T3 to...
Offered is a brake set for the fixed caliper brake system, installed to approx. Bj. 1985 Consisting of: 2x ATE brake disc 1x ATE brake pad set 1x TRW retaining spring set 2x FAG wheel bearing set
€184.95
*
€188.32
*
Stabilizer bearing set incl. coupling rods, T3...
Offered is a stabilizer bearing set including coupling rods and mounting hardware for T3 Syncro with sheet metal wishbones to approx. Bj. 1988. Consisting of: 2x coupling rod 2x bearing inside 2x bearing outside 4x damping ring 4x disc...
€324.95
*
€345.50
*
Sealing set for window pane incl. piping and...
Offered is a seal set for the window pane with groove for keder, including keder and sleeves, suitable for the T3 up to Bj. 1984. Consisting of: 4X connection sleeve 2X chrome piping 4X Connecting sleeve for half round chrome piping 4X...
€348.95
*
€367.32
*
Transmission gasket set T3 Syncro OE Ref....
On offer is a complete gearbox gasket set with everything you need. Consisting of: Transmission cover gasket Clutch housing seal Bearing shield seal 2X oil seal drive shaft flange 2X Sealing ring drive shaft flange 2X Drive shaft flange...
€72.95
*
€77.25
*
Assembly and sealing kit for tank T3 up to year...
We offer a gasket set which contains everything you need to fit the tank. The assembly kit consists of: Seal for fuel filler neck Ventilation hose complete with elbow piece 3X seal for pressure equalization line O-ring seal for tank...
€126.49
*
€135.29
*
Sealing kit for tank T3 from year 83 OE Ref....
We offer a gasket set which contains everything you need to fit the tank. The assembly kit consists of: Seal for fuel filler neck 3X seal for pressure equalization line O-ring seal for tank sensor 2X seal for fuel expansion tank 1 meter...
€41.95
*
€45.44
*
Strut or shock absorber (BILSTEIN) completely...
On offer is a set of completely pre-assembled shock absorbers (BILSTEIN) for the rear axle. This means that the shock absorbers can be replaced relatively easily. In addition, no special tools are required. The lower shock absorber bolts...
€364.95
*
Viewed